CyberHome Entertainment CH-DVD 452 Manuel d'utilisateur télécharger pdf (Page 20)

Video connection to a TV/Beamer with Component

Video inputs (YCbCr/YPbPr)

Component video separates the video signal into three separate “components”,

resulting in a higher picture quality than S-Video or standard composite video.

In order to use component video, you have to use a TV/Beamer equipped with

component video inputs.

You will also need a component/P-Scan video cable (not included) with sepa-

rate connectors for Y, Cb/Pb and Cr/Pr signals. This type of cable also supports

the Progressive Scan mode when used with high-end P-Scan TVs. Using the

component video output or P-Scan mode requires the following steps:

1. Preparation:

- First, use an audio/video cable or S-Video cable to connect the DVD play-

er to the composite video or S-Video input on your TV/beamer.

- As this device has a fixed power cord, only plug the other end of the fixed

power cord into the wall socket.

- Turn on the TV/beamer and the DVD player and select the corresponding

video input on your TV/beamer.

2. Entering the setup menu to change the Video setting:

Enter the player’s setup menu by pressing the “SETUP” button on the

remote control. Use the direction button “A” to navigate to the “Video” setup

page, then press “ENTER” navigate down to the “Video output” menu and

press “ENTER” to enter the menu. Use the direction button

“D” to proceed down to the “YUV” setting and press “ENTER” to confirm

your selection. On the screen will now be displayed a warning hint. Follow

the instructions on the screen.

3. Connecting the player using the Component Video cable:

Unplug the Composite Video or S-Video cable and connect the Component

Video cable to the appropriate jacks on your TV/Beamer. Normally, cables

and jacks are color-coded to make the connection easier. Then adjust the

TV’s/Beamer’s video input setting to correspond to the component video

input.

AUDIO AND VIDEO CONNECTIONS

COMPONENT VIDEO CABLE

TV or

Beamer

COMPONENT

VIDEO INPUT



ENG

Language Video Audio Security General

Video settings

TV shape Wide S-Video

TV system PAL YUV

Video output S-Vi RGB

Video mode

Sharpness Mid

Brightness 00

Contrast 00

Set the video output

4. Using a Progressive Scan TV: To switch from Interlace to Progressive

Scan, please read section “Video mode” on page 43.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 51 52

Commentaires sur ces manuels

Pas de commentaire

CyberHome Entertainment CH-DVD 452 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Lecteurs de DVD CyberHome Entertainment CH-DVD 452